|
|
WS6108#show int aggregateport 1
Index(dec):15 (hex):f
AggregatePort 1 is UP , line protocol is UP
Hardware is AggregateLink AggregatePort, address is 5869.6c20.726a (bia 5869.6
c20.726a)
Interface address is: no ip address
Interface IPv6 address is:
No IPv6 address
MTU 1500 bytes, BW 2000000 Kbit
Encapsulation protocol is Ethernet-II, loopback not set
Keepalive interval is 10 sec , set
Carrier delay is 2 sec
Ethernet attributes:
Last link state change time: 2015-09-07 17:52:22
Time duration since last link state change: 0 days, 0 hours, 0 minutes, 6
seconds
Priority is 0
Medium-type is Copper
Admin duplex mode is AUTO, oper duplex is Full
Admin speed is AUTO, oper speed is 1000M
Flow control admin status is OFF, flow control oper status is OFF
Bridge attributes:
Port-type: access
Vlan id: 1
Aggregate Port Informations:
Aggregate Number: 1
Name: "AggregatePort 1"
Members: (count=2)
GigabitEthernet 0/7 Link Status: Up
GigabitEthernet 0/8 Link Status: Up
Load Balance by: Source IP and Destination IP
Rxload is 1/255, Txload is 1/255
10 seconds input rate 867 bits/sec, 1 packets/sec
10 seconds output rate 867 bits/sec, 1 packets/sec
13 packets input, 1084 bytes, 0 no buffer, 0 dropped
Received 3 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 abort
13 packets output, 1084 bytes, 0 underruns , 0 dropped
0 output errors, 0 collisions, 0 interface resets
建议聚合之后设备上显示的speed的值是两个带宽总值
|
|
发表于 2015-9-7 19:48:19
